| 0,0 → 1,61 |
|---|
| ### This file controls the configuration of the svnserve daemon, if you |
| ### use it to allow access to this repository. (If you only allow |
| ### access through http: and/or file: URLs, then this file is |
| ### irrelevant.) |
| |
| ### Visit http://subversion.apache.org/ for more information. |
| |
| [general] |
| ### The anon-access and auth-access options control access to the |
| ### repository for unauthenticated (a.k.a. anonymous) users and |
| ### authenticated users, respectively. |
| ### Valid values are "write", "read", and "none". |
| ### Setting the value to "none" prohibits both reading and writing; |
| ### "read" allows read-only access, and "write" allows complete |
| ### read/write access to the repository. |
| ### The sample settings below are the defaults and specify that anonymous |
| ### users have read-only access to the repository, while authenticated |
| ### users have read and write access to the repository. |
| # anon-access = read |
| # auth-access = write |
| ### The password-db option controls the location of the password |
| ### database file. Unless you specify a path starting with a /, |
| ### the file's location is relative to the directory containing |
| ### this configuration file. |
| ### If SASL is enabled (see below), this file will NOT be used. |
| ### Uncomment the line below to use the default password file. |
| # password-db = passwd |
| ### The authz-db option controls the location of the authorization |
| ### rules for path-based access control. Unless you specify a path |
| ### starting with a /, the file's location is relative to the the |
| ### directory containing this file. If you don't specify an |
| ### authz-db, no path-based access control is done. |
| ### Uncomment the line below to use the default authorization file. |
| # authz-db = authz |
| ### This option specifies the authentication realm of the repository. |
| ### If two repositories have the same authentication realm, they should |
| ### have the same password database, and vice versa. The default realm |
| ### is repository's uuid. |
| # realm = My First Repository |
| ### The force-username-case option causes svnserve to case-normalize |
| ### usernames before comparing them against the authorization rules in the |
| ### authz-db file configured above. Valid values are "upper" (to upper- |
| ### case the usernames), "lower" (to lowercase the usernames), and |
| ### "none" (to compare usernames as-is without case conversion, which |
| ### is the default behavior). |
| # force-username-case = none |
| |
| [sasl] |
| ### This option specifies whether you want to use the Cyrus SASL |
| ### library for authentication. Default is false. |
| ### This section will be ignored if svnserve is not built with Cyrus |
| ### SASL support; to check, run 'svnserve --version' and look for a line |
| ### reading 'Cyrus SASL authentication is available.' |
| # use-sasl = true |
| ### These options specify the desired strength of the security layer |
| ### that you want SASL to provide. 0 means no encryption, 1 means |
| ### integrity-checking only, values larger than 1 are correlated |
| ### to the effective key length for encryption (e.g. 128 means 128-bit |
| ### encryption). The values below are the defaults. |
| # min-encryption = 0 |
| # max-encryption = 256 |